GiBiDi DGF Serie Installationsanleitung Seite 7

DGF
INSTALLATION
Secure or build the containers into a wall making sure to extract the optical-electronic part. The containers must be
installed in frontal position aligned on the same axis and at the same height from the ground.
Arrange the connection cables (0.5 mm²) leading into the containers connecting them to the respective terminal
boards of the receiver and transmitter (Fig.1/Fig.2).
Insert the optical-electronic part into the container and slide it to the bottom until the front is perfectly flush (if there is
resistance, the connection cables are probably too long). Secure the optical-electronic part to the container with 4
screws at the front. Power the photocell. Act on the adjusting screws (horizontal and vertical) of the transmitter and
receiver.
The photocell is set up to operate in synchronised mode. In this mode the photocells function only if
powered with alternate voltage. When making the connections, pay attention to the exact position of the
cables A and B (Fig.3).
Check several times that the relays respond normally by interrupting the infrared ray.
Secure the front protection panel of the photocell with screws and again check functioning.
Jumper J1 operation:
CLOSED= Standard operation
OPEN= Delayed operation, to be used in particular atmospheric conditions (snow).
N.B.: Do not set delayed operation with the synchronism.
Gi.Bi.Di. reserves the right to make modifications at any time without prior notice.
UKCA Declaration of conformity
The manufacturer:
Declares that the products:
Are in conformity with the essential requirements and other relevant requirements of:
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012
Electrical Equipment (Safety) Regulations 2016
Radio Equipment Regulations 2017
And that the following harmonised standards have been applied:
EN 301 489-1 V2.2.0; EN 301 489-3 V2.1.1; EN 300 220-2 V3.2.1; EN 62479:2010;
EN 60950-1:2014;
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Date: 02/04/21
EU manufacturer declaration: The EU declaration is available at: http://conformity.gibidi.com
GI.BI.DI S.r.l.
Via Abetone Brennero, 177/B,
46025 Poggio Rusco (MN) - ITAL
DGF100_AU02260; DGF200_AU02270
The legal Representative
Michele Prandi
7
UK