Connection Of The Components; Warranty Disclaimer - Xavax 00220739 Bedienungsanleitung

G Operating instruction
The product is intended for private, non-commercial use only. Do not operate the product outside the power limits given in the
speci cations. Do not operate or continue to use kinked or damaged lines, connections or lters. In case of doubt, setup should
only be carried out by a specialist.
Use the product only for the intended purpose. Do not modify the product in any way. Doing so voids the warranty.

Connection of the components:

To make installation easier for you, all components are equipped with high-quality "Speed t™" attachments. These allow you to
set up and dismantle the system quickly and easily without tools. Before connecting, make sure that the hose is cut straight and
then push the hose approx. 1.5 cm into the attachment. Secure the line with the securing ring (see g. X and XI). To dismantle a
connection, rst remove the securing ring, then push the plastic ring in the direction of the attachment and pull out the hose (see
FIG XII).
Make sure that the hose is long enough to prevent tension on the individual components or connections. Make sure that the
hose is not kinked to ensure even water intake. The hose must not come into contact with sharp edges or hot appliances (e.g. hot
water pipes). Suitable for a temperature range +1°C - +20°C, max. operating pressure 10 bar, max. burst pressure 30 bar. We
recommend attaching the hose to your kitchen wall with suitable clips.
Warning
The refrigerator must be switched off and unplugged before installation. If the system is already connected to the water tap, the
tap should be turned off.
With a sharp knife, cut the 1/4" hose (D) straight. The cut must be at a right angle (90°) so that the connection seals.
Screw the 3/4" connector (A) onto the cold water connection.
Insert the hose (D) into the connector (A) as far as it will go (approx. 1.5 cm).
Generously calculate the length and do not mount the hose under tension.
For connection to the refrigerator, water puri er or ice cube maker, there are several options available
according to the unit:
• Option A: Connect the hose (D) directly to the water lter.
• Option B: 1/4" hose connection; use the straight connector (B).
• Open the water tap and check the entire system for leaks. Repeat the installation if necessary.
• Close the rear panel and switch the refrigerator on again according to the operating instructions.
• Check the system 24 hours after installation. If you nd dripping connections, install each of them again: turn off the tap and
release the water pressure by emptying the refrigerator's water dispenser. Take the hose from the dripping connection point and
cut off at least 5 mm. Then install the hose again, turn on the tap and check all other connections.
• All system attachments must comply with local speci cations.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating instructions and/or safety notes.
2