General Safety Instructions - LightPro Ixion Small Bedienungsanleitung

GENERAL SAFETY INSTRUCTIONS

It is preferable to have installation and repair carried out by a qualified electrician.
Caution! During installation or any intervention in the luminaire (lamp replacement, cleaning, etc.) or in case of
malfunction, always unplug the luminaire (in case of direct connection, switch off the power in the distribution board).
Follow the symbols and safety instructions below to prevent incorrect installation or misuse.
IP xx
IP xx
IP xx
IP xx
IP xx
IP xx
Modifications: Do not make any changes to the lighting or power cord.
Commissioning: Do not connect the lighting if the luminaire or power cable show signs of damage.
Power supply replacement: Before replacing the power supply, disconnect the luminaire from the mains. Ensure that
the luminaire or source is not hot and, if necessary, wait for it to cool down. Only use sources suitable for the particular
luminaire. This information is indicated on the luminaire. The maximum current must never be exceeded.
Maintenance instructions: The luminaire should only be cleaned when it is switched off. Ensure that no moisture
enters the area of power cable or live parts! The use of unsuitable cleaning agents may cause staining or surface
damage. In addition to these safety instructions, it is also necessary to follow the instructions in the operating
instructions and accompanying documents.
8
Protection class 1: Lamps and devices of this class must be connected to an earthed
socket. These devices require an earth wire (yellow-green).
Protection class 2: Lamps and appliances of this class are already insulated and do not
require an earth wire (yellow-green).
Protection class 3: Lamps and devices of this class are connected to a safe low voltage.
Protection is obtained by using Safety Extra Low Voltage (SELV).
Minimum distances: This symbol indicates the minimum distance from the illuminated
normally flammable surface.
Recessed luminaires: The luminaire must not be covered with insulating material.
IP protection: IPx1 - protection against vertically falling water droplets. IPx3 - protection
against falling splash water up to 60⁰ from the vertical. IPx4 - protection against
splashing water from all directions. IPx5 - protection against water jets (spray) from all
angles. IPx7 - protection against temporary immersion in water. IPx8
- protection against prolonged immersion in water (time and depth indicated by
the manufacturer). IP5x - dust protection. IP6x - dustproof.