Primewire 303134 Bedienungsanleitung Seite 8

3. Attributes
With this HDMI switch you can connect up to five devices to an HDMI port. The
switch detects if a connected device is turned on and switches automatically to the
appropriate channel. Optionally, you can also switch manually between five chan-
nels by using the button on the top of the device or the remote control.
4. Initial startup
Please take the HDMI switch and infrared receiver out of the package. Unpack the
remote control and remove the strip that is sticking out of the battery compart-
ment on the backside. Turn off all devices you want to connect and connect then
with an appropriate HDMI cable with the switch.
Devices which are built for the European market, should always provide a 5 volt
power supply according to the HDMI specifications. However, some devices are
not able to provide this energy.
In this case, there is a DC hollow plug power on the HDMI switch where can feed
voltage (5V DC). So it is easy to establish a connection with the help of the included
DC hollow plug power. You only have to plug it into a properly wired outlet and
connect the DC hollow plug power with the HDMI switch.
5. Auto-Select function
The HDMI switch will select the active port automatically. There are priorities in
the following way: Input 1> Input 2> Input 3> Input 4> Input 5. Once you have con-
nected and switched on a new source, the HDMI will switch automatically to this
input. When the current active source is turned off, the HDMI switch will switch
automatically to the next higher input receiving an active signal.
6. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibration as this might damage
electronic components. Examine the device for damage before using it. The unit
8
English