Bibby Scientific Stuart STR4 Bedienungsanweisung Seite 4

Accessory Drums
STR4/1: Designed for rotating tubes in an
end-over-end movement. The STR4/1
consists of a square metal drum which can
accommodate up to four plates fitted with
clips for various size tubes.
All clip plates are interchangeable and may be
fitted to any face of the drum. To fit the clip
plate to the drum, insert the locking pins into
the holes on any one face. Ensure that the
button on the left hand end face of the drum
is pressed in, flush with the drum. Press the
clip plates well into the drum then push the
button on the right hand face of the drum
inwards to lock the clip plate in position.
Fig. 2: STR4/1
SRT4/2: Designed to hold two x 250ml flasks
or reagent bottles for end-over-end mixing.
The vessels are securely held in place by a
collar that fits around the neck of the flask or
bottle and is secured by two washers.
Fig. 3: STR4/2
STR4/3: Designed to hold a single vessel at
a 45º angle so that it is rolled and turned
end-over-end at the same time, resulting in a
vigorous figure of 8 mixing action. The vessel
is held firmly in place by strong Velcro® straps.
The maximum vessel size is approximately
200mm in length, 120mm diameter.
Fig. 4: STR4/3
STR4/4: Consists of a four segment Perspex®
cradle. Each segment is fitted with a fully
adjustable Velcro® strap to hold bottles and
other containers up to 120mm in diameter
and 300mm in length.
Fig. 5: STR4/4
STR4/5: Designed for thorough end-over-end
mixing of 1.5ml microcentrifuge tubes. STR4/5
includes 4 racks, each of which can
accommodate up to 60 tubes. Individual racks
are easily removed by removing a locking knob
and sliding the rack out of the cradle.
Fig. 6: STR4/5