Swiss Peak P328.141 Bedienungsanleitung Seite 4

CHARGING:
1. Connect the charger to the charging port (7)
2. While charging the LED indicator (8)will be solid red. When fully
charged the LED indicator (8) will be blue.
PAIRING:
1. Turn on the headphones by pressing and holding down the phone
button on the headphones for three seconds
2. The device's LED indicator will illuminate. The LED indicator light will
blink between red and blue when it is in pairing mode.
3. On the mobile device (smartphone/tablet) turn on the Bluetooth
connection.
4. Select "Swiss peak ANC" in the available Wireless devices on your
mobile device.
5. If asked for a PIN or passcode enter "0000". If your device supports
Secure Simple Pairing (SSP), you will need to enter a Pass/PIN code
To reconnect:
Simply turn on the headphones and have Bluetooth turned on your mobile
device and the headphones will automatically reconnect.
CALLS:
Incoming calls: During incoming calls the headphones will acknowledge
there is an incoming call. If music is playing it will mute the music.
To accept the call, press the Play/ Pause button.
End call: Press the Play / Pause button.
Ignore call: Press and hold the Phone/Play/Pause button for 2 seconds.
ANC:
Switch to ANC function (4) the noise cancelling function will be active and
the LED indicator (5)is green.
Press button (4)again and you can turn off the noise cancelling function.