Selecting The Mode Of Operation; Maintenance And Cleaning; Ordering Replacement Parts - EINHELL ERGO TOOLS E-LS 2445 Bedienungsanleitung

Anleitung E-LS 2445 SPK7
To switch on, push the ON/OFF switch (5)
toward ON. To switch off, push the ON/OFF
switch toward 0FF.

7.3 Selecting the mode of operation

7.3.1 Vacuum (Abb. 7)
Turn the lever (8) all the way left to "Vacuum".
You can do this regardless of whether the tool is
running or not.
7.3.2 Blowing (Fig. 7)
Turn the lever (8) all the way right to "Blower".
You can do this regardless of whether the tool is
running or not.
Channel the air stream forward and walk slowly
to blow foliage or garden refuse into a pile or to
clear out hard-to-reach places.
Important!
Empty the debris bag before blowing. Otherwise, the
material that has been vacuumed up could drop out.
7.3.3 Emptying the debris bag and pre-screen
(Fig. 1)
Empty the debris bag (7) in good time. When the bag
is heavily loaded with material, vacuum power is
considerably reduced. Deposit organic refuse at a
compost site.
Switch off the tool and pull out the plug.
Open the zipper on the debris bag (7) and
shake out the material.

8.0 Maintenance and cleaning

IMPORTANT!
All maintenance, service and cleaning work must
be performed after the power cord has been
pulled out.
Do not use high-pressure cleaners or running
water to clean the tool.
Do not use any aggressive cleaning agents.
After shaking out the debris bag, turn it inside
out and thoroughly clean it in order to prevent
mould and unpleasant odors from forming.
You can use soap and water to clean out a
heavily soiled debris bag.
Rub a bar of dry soap across the zipper teeth if
the zipper becomes difficult to pull.
Always keep the tool and ventilation slats clean.
Use a damp rag to wipe dirt marks off of the
tool. Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
17.01.2006 15:05 Uhr Seite 13
Dirt and grime can make the switch
(blower/vacuum) more difficult to operate as a
result of the material that swirls up off the
ground. When this occurs, simply flip the switch
back and forth a few times, which should bring it
back to the normal feel.
9.0 Repair
Should the tool experience problems beyond those
mentioned above, let only an authorized professional
or a customer service shop perform an inspection.
10.0 Disposal
The tool, accessories and packaging should be
disposed of in an environmentally-friendly fashion.
Plastic parts are coded for purposes of separation
when recycling.

11. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
13