Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Overheat Protection - Team FH 901 Gebrauchsanleitung

Heizlüfter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Fax +32 2 359 95 50
POSITIONING OF THE APPLIANCE
The heater should only be operated at a minimum distance of 50cm from any wall or other
object. Position the air flow in order to optimise the heating of the room. Avoid corners, small
volumes, floors and ceilings.
The handle of this appliance has two openings that allow mounting the appliance on the wall
(use screws with big enough a head so that these cannot pass through the openings in order
to assure that the appliance is fixed tightly on the wall). The appliance will then be oriented
automatically downwards in the room in order to provide better efficiency.

OPERATION

When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation. This smell will disappear very quickly.
Place the power selector in "0" position, the thermostat on its minimum position and put the
plug in a 230V power socket.
The selector allows you to choose the desired power. The higher the power, the faster the
heating.
The thermostat regulates the temperature in the room. A red pilot light will indicate that the
appliance is operating.
When the selector is in
Power selector
0
OFF
Fan without heater
1
1000 W
2
2000 W
Note: before switching off the appliance, we advise you to operate it in
minutes in order to cool it down.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids. In this
case, unplug the appliance, wait about 10 minutes for it to cool and remove the object that is
obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
position, the appliance operates as a fan, but will not heat.
6
Assembly page 6/23
position for 2 to 3
TEAM FH 901 - 070604

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis