Technical Data - Rev Ritter Ges-283 Bedienungsanleitung

GB
Multiple socket with surge protection
Installation and Operating Instructions
INTRODUCTION
Dear Customer,
We'd like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.
PROPER USE
• The product conforms to the appropriate European CE directives (S2).
• This product conforms to the appropriate European safety standards.
• The product is IP20 rated and suitable for use in dry interior spaces (S3).
• The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
• The product is not intended for use by persons (including children) whose physical, sensory or mental abilities
are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!
• Make sure that this product is kept out of the reach of children or unauthorised persons.
GENERAL INFORMATION
• Handle this product carefully. It can be damaged by shocks, blows or by being dropped, even from a low height!
• Disconnect the product's mains power plug in the event of a fault during operation.
• This product has no replaceable parts. Do not attempt to open or repair this product!
• The product is a portable multiple socket outlet. Do not operate while permanently mounted!
GENERAL SAFETY INSTRUCTIONS
• Please observe the technical specifications!
• Please follow this instruction manual and keep it in a safe place!
• Please pass on this instruction manual to a subsequent owner!
• Not to be used by children!
• Do not operate a defective product!
• Use only in connection with a sufficiently fused 230V~ installation!
• Do not operate the product when covered (S4). This could lead to a dangerous buildup of heat!
• The product must remain freely accessible (also when in use)!
• For the connection, only use regular mains sockets (230V~, 50Hz) with protective conductors of the public
supply network which are easily accessible!
• A conversion or modification of the product affects product safety. Caution: risk of injury! A conversion or
modification of the product must not be carried out!
• If the cable is damaged, disconnect product from the power supply!
• De-energised only when the plug is pulled out (S5)!
• Do not plug one behind the other (S6)!
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• Do not expose the product to direct sun and shield it from extreme heat!
• In spite of their high energy dissipation capacity, direct lightning strikes do not provide absolute safety for
connected devices!
• Devices which have an additional connection in addition to the power connection (e.g. antenna cable,
telephone line, etc.) must have their own surge protection for this input!
• Plugged-in power supply units must not exceed a temperature of 50°C.
• To avoid damage, do not bend or knot cables over sharp edges or corners!
• Only connect devices up to max. 3680W total power!
6
• The overvoltage protection strip is an effective protection against overvoltages between the outer conductor
(phase) and the neutral conductor (middle conductor) against the protective conductor in the 230V~ power
supply system. When overvoltages occur, the built-in electronic components establish a connection between
the conductors and reduce the dangerous overvoltage. The electronics in the surge protection strip are ready for
operation even after several „normal" responses. In the event of an overload, the surge protector is disconnected
from the mains to prevent fire hazards. The indicator light goes out in this case. The surge protector cannot be
repaired. The power strip can still be used as a normal power strip without surge protection.

TECHNICAL DATA

• Nominal values: 230V~; 50Hz; 16A
• IP protection class: IP20
• Protection class: I (S7)
• Ambient temperature: -5°C - +35°C / max. 40°C
• Dimensions W x H x D: 640 x 75 x 50mm
• Over-voltage protection
- UCP: UC: 275V~
- OCV: 6.0kV for L/N-PE
- OCV: 3.0kV for L/N
- Up: 2.0kV
- Type 3 according to standard EN 61643-11
• Supply line: 2m H05VV-F 3G1.5mm²
• Switch: two-pole disconnection
• Continuous operation possible
• Power: max. 3680W
• Socket outlet with increased contact protection
• LED indicator: When the indicator is green, the overvoltage protection is ready for operation. When the display is
off, the overvoltage protection has tripped and is defective. The power strip can be used as a normal power strip
without surge protection.
CLEANING
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
WEEE DISPOSAL INFORMATION
According to the European regulations, used electrical and electronic equipment may no longer be put out into
unsorted rubbish. The symbol on the wheeled rubbish bin points out the necessity for separated collection. Help
us to protect the environment and ensure that this unit is put out in the appropriate systems for separate collection
once you do not use it any longer. DIRECTIVE OF THE EUOROPEAN PARLIAMENT AND COUNCIL of 4th July 2012
concerning used electrical and electronic equipment (S8).
SERVICE
If you have any questions concerning our products or a complaint, then please go to www.rev.de to find out how to
make contact or how to organise a return. Alternatively, send an email to service@rev.de. We'd like to point out
that we are unable to process any shipments which do not have a return number and will not accept them.
GB
7