Braun 750 cc-6 Bedienungsanleitung Seite 14

14
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. The contacts
shaver will align with the contacts
cleaning station. Important: The shaver needs
to be dry and free from any foam or soap
residue!
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
4
start button . For best shaving results, we
recommend cleaning after each shave.
Whilst cleaning is in progress, the respective
cleaning program indicator will blink. Each
cleaning program consists of several cycles,
where cleaning fl uid is fl ushed through the
shaver head and a heat drying process dries
the shaver. Depending on the program selected
the total cleaning time will range from 32 to 43
minutes.
The cleaning programs should not be inter-
rupted. Please note that whilst the shaver is
drying, the shaving head may be hot and wet.
When the program is fi nished, the blue
indicator will light up. Your shaver is now clean
and ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The green indicator fl ashes when the shaver is
being charged or when in use.
When the battery is fully charged, the charge
segment / will light up continuously provided
that the shaver is switched on or connected to
an electrical outlet.
u
on the back of the
3
in the
5
will