Removing The Transportation Locks; Appropriate Installation Location; Removing Packaging Reinforcement - Beko WTV 8140 XWO Bedienungsanleitung

2 Installation
Refer to the nearest Authorised Service Agent for installation
of the product. To make the product ready for use, review
the information in the user manual and make sure that the
electricity, tap water supply and water drainage systems are
appropriate before calling the Authorized Service Agent. If
they are not, call a qualified technician and plumber to have
any necessary arrangements carried out.
C
NOTE :
Preparation of the location and electrical, tap
water and waste water installations at the place of
installation is under customer's responsibility.
NOTE :
Make sure that the water inlet and discharge
hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into its
place after installation or cleaning procedures.
B
DANGER:
Installation and electrical connections
of the product must be carried out by the Authorized
Service Agent. Manufacturer shall not be held liable for
damages that may arise from procedures carried out by
unauthorized persons.
A
CAUTION:
Prior to installation, visually check if the
product has any defects on it. If so, do not have it
installed. Damaged products cause risks for your safety.

2.1 Appropriate installation location

• Place the machine on a rigid floor. Do not place it on a
long pile rug or similar surfaces.
• Total weight of the washing machine and the dryer -with
full load- when they are placed on top of each other
reaches to approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient load carrying
capacity!
• Do not place the product on the power cable.
• Do not install the product at places where temperature
may fall below 0ºC.
• Place the product at least 1 cm away from the edges of
other furniture.

2.2 Removing packaging reinforcement

Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon.
28 / EN

2.3 Removing the transportation locks

A
WARNING:
Do not remove the transportation locks
before taking out the packaging reinforcement.
WARNING:
Remove the transportation safety bolts
before operating the washing machine! Otherwise, the
product will be damaged.
1. Loosen all the bolts with a suitable spanner until they
rotate freely (C) .
2. Remove transportation safety bolts by turning them
gently.
3. Attach the plastic covers supplied in the User Manual bag
into the holes on the rear panel. (P)
C
NOTE :
Keep the transportation safety bolts in a safe
place to reuse when the washing machine needs to be
moved again in the future.
NOTE :
Never move the product without the
transportation safety bolts properly fixed in place!
Washing Machine / User's Manual