Basic Operations; Power On / Off; Playing Source Selection; Volume Adjustment - XZENT XT7012 Bedienungsanleitung

Basic Operations

Power On / Off

Press the POWER OFF /VOL button to turn the unit on. The buttons on the front panel of the unit
are illuminated. You can also turn on the unit by pressing the POWER button (
remote control.
Press and hold the POWER OFF /VOL button on the front panel for more than 1 second or
press the POWER button ( ) on the remote control to power off the unit. The monitor is drawn
back into the main compartment.

Playing Source Selection

Press the MODE button on the front panel or the (SRC) button on the remote control to change
among available playing sources: TUNER, DVD, AUX IN, USB. The playing mode is displayed on
the TFT display.

Volume Adjustment

To increase or decrease the volume level, turn the POWER OFF/VOL on the front panel or press
the (VOL+/ VOL-) buttons on the remote control. The volume ranges from "0" to "40". The default
volume is "10" each time when the unit is powered on. Default volume memory setup: Rotate
Power Off/VOL knob on the front panel to select volume value and then press and hold the Power
Off/VOL button. If you try to store a volume above 20, the default value is automatically capped to
20. The default volume for traffic anouncements can be adjusted separately. Maximal TA volume
value is not capped.

Audio Control Menu

The audio control feature allows you to easily adjust your audio system to meet the acoustical
characteristics of your vehicle, which vary depending on the type of vehicle and its design and
acoustic dispersion. To get the best possible sound quality from your new system, be sure to adjust
the settings for the speakers as well. Proper setting of the fader and balance boosts the effects of
the cabin equalizer. For plain linear amplification choose flat, or the original USER settings.
Audio adjustments
Audio Function Adjustable Range
EQ Flat
Jazz
Pop
Classical
Rock
News
Urban
Rave
Movie
Techno
User
BASS -7 to +7
TREBLE -7 to +7
BALANCE -9 to +9
FADE -9 to +9
LOUD off, on
) on the
12
NOTE: The bass and treble levels are only adjustable when EQ is in "User" mode.
The loudness function compensates for deficiencies in sound ranges at low levels. When the
loudness function is on, LOUD is displayed on the screen.
Exiting the audio control menu
Touch the return arrow on the top right of the display.
Press the (ESC) button on the remote control to exit the audio control menu.

System Reset

To correct a system halt or other unusual operation, use the tip of a pen to press the RESET button
located on the front bottom-right corner of the unit.
13