Care & Cleaning - Arzum PROSTICK MULTISPEED 2000 Gebrauchsanweisung

WARNING
1- NEVER operate your Arzum Prostick Multispeed 2000 Hand
Blender Set unless the main body is attached to the cutter adapter.
2- Do not lift the main body from its slot unless the motor fully stops.
3- Store the cutting blades in the bowl, since they are very sharp.
CARE & CLEANING
In order to ensure many years of proper operation, due care and cleaning
of your Arzum Prostick Multispeed 2000 Hand Blender Set will be too
easy and short.
• Ensure that the mains plug is disconnected from the wall socket before
cleaning the unit, and allow it to cool down for a while.
• It is very important for you to rinse the accessories
immediately after using, so that the overall cleaning of the
appliance can be easier.
Motor (Main body): NEVER immerse into water or other
liquids. Wipe the outside with a slightly damp cloth and
down with the blade in the upright position.
Beater Adapter: NEVER immerse into water or other
liquids. Wipe the outside with a slightly damp cloth and
of your Arzum Prostick Multispeed 2000 Hand
Blender Set by using water and soap, or in the
upper section of a dishwasher.
Repeat the same steps after each use.
then dry thoroughly.
Metal Grinder and Mixer: Rinse using
tepid water and soap. When cleaning under running
water, take care not to leak any water into the slot
on which the motor is located. If water leaks into
the slot, immediately turn upside down and shake
it out, and then allow it to cool
then dry thoroughly.
Cutter Adapter: NEVER immerse
into water or other liquids. Wipe
the outside with a slightly damp cloth and then dry
thoroughly.
You can wash bowl, double sided stainless steel
cutting blades, and beaters
EN
ARZUM 19