Polar CD239 Bedienungsanleitung Seite 4

EN
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
Ventilation
• Locate the appliance in a dry place.
• Protect against direct exposure to sunlight
and sources of heat or draughts including
air currents such as radiators, fans, air
conditioning units and doors, etc.
• Install the appliance in a place with good
natural ventilation to increase ventilation
properties.
• Multidecks generate a considerable amount of
heat and, if operated in a small unventilated
room will quickly cause the room temperature
to become excessive. This could cause the
motor to overheat and possibly damage
the compressor. At the very least, such an
installation will cause the unit to use an
excessive amount of electricity.
• Poor ventilation / excessive heat can cause the
multideck to produce excessive condensation.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water then dry well.
3. Set the brakes on the castors to keep the
appliance in position.
4
CD239_ML_A5_v7_20230302.indb 4 CD239_ML_A5_v7_20230302.indb 4
Operation
Control Panel
• Plug the mains lead in to the socket and switch
on, then turn on product using the mains
switch (this will light up).
• When the refrigeration system is operating
the left hand LED will be lit, when it reaches
temperature and turns off the LED will go out.
Digital Temperature Controller
Operation
1. Press SET button. The set temperature is
displayed.
2. Press or button to modify and store the
displayed value.
3. Press SET button to exit the adjustment and
within 10 seconds, the Multideck temperature
will be displayed.
Lighting
To turn on the display light press
off press again.
Manual Defrost
Press button and hold for 6 seconds to start or
stop the defrost process.
button. To turn
2023/3/2 13:16 2023/3/2 13:16