Vogue FS487 Bedienungsanleitung Seite 3

To Start Weighing:
1. Place the bowl included on the scale (if necessary).
2. Press "ON/OFF" to turn on. Wait until display shows "0".
3. Load weighing object on the scale (or in the bowl) to start weighing. Display will show the weight
reading.
"ZERO" or "TARE" function
To weigh different loads consecutively without removing previous loads from the scale:
1. Put first Load on the scale and get weight reading.
2. Press "Z/T" button to reset the reading to "0" before adding next load. You can repeat this operation.
Condition 1: "ZERO" function
When total sum of all loads on scale is ≤4% of scale's maximum weight capacity (4% here means 200g
with this scale), display will show "-----" or "0 g" each time "Z/T" button is pressed.
"-----" means reading is not stable. Please wait for a moment. "0 g" and meanwhile an icon "ZERO" on
the left side of display indicate ZERO function is activated. In this case, maximum weight capacity remains
unchanged.
Condition 2: "TARE" function
When total sum of all loads on scale is >4% of scale's maximum weight capacity (4% here means 200g
with this scale), display will show "-----" or "0 g" each time "Z/T" button is pressed.
"-----" means reading is not stable. Please wait for a moment. "0 g" and meanwhile an icon "TARE" on the
left side of display indicate TARE function is activated. In this case, maximum weight capacity is reduced
by total weight of all loads.
Under this condition:
• By pressing "Z/T", you can see the total weight of all loads on the scale.
• To weigh more loads, just press "Z/T" to reset reading to '0' again.
To set the alarm timer
1. Press "ON/OFF" to turn on.
2. Press "T-SET" to enter alarm setting.
3. Press or to set the time span. Maximum time span: 99:59 (99 minutes and 59 seconds).
4. Press "T-SET" to confirm. The timer will start to count down.
Note: If desired, you can press any key to stop counting down, then press "T-SET" to clear
the timer setting.
5. The buzzer will sound when display counts down to "00:00".
Ambient temperature indication
Ambient temperature will be shown on the right top zone of the display.
FS487_ML_A5_v2_20230616.indb 3
EN
3
2023/6/16 9:25:39