RUNZEL RZL-830 Bedienungsanleitung Seite 13

• Never fill up the device with hot water.
• Close the tank cover again and mount the tank into the
device, Figure 10, Figure 11.
• Pull out the cord, insert the plug into the socket and
switch on the device, Figure 12, Figure 13.
• Steam indicator will lit up in approximately one minute;
watch the indicator.
• Holding the brush pull the steam tube out of the casing.
Locate a fabric vertically onto the brush and start ironing
from top downward, Figure 14.
• In the course of operating, there is a sound of flowing
water; it is absolutely normal. If you hear such sound,
pull the tube upward.
• In order to extend the service life of the device, it
is necessary to empty the tank upon completion of
operation and to switch on the device for 5 minutes
in the drying mode to dry it. As soon as steam stops
generating, the device may be switched off.
Operation manual for components
Memento: When components are used, they must
be cleaned only in the vertical position; under no
circumstances the components shall be cleaned in
horizontal position.
• Before using the components, read attentively the
manual; moreover, we recommend a test run with an
obsolete fabric.
Brush
• The brush is intended for the steam to penetrate into
fabric more effectively, thus enhancing the ironing
process.
• Memento: Get the device cooled before mounting the
brush.
• To mount the brush, remove a screw cap, then slightly
press the nozzle and lock up the clamp.
• Move the device with brush from top downward. Before
dismounting the brush, switch the device off. If no
steam is coming from the brush, it may be removed.
Never touch the elements made of stainless steel, it
may lead to burns.
Iron tire
• The tire helps to easily iron the edging and shrink
cloth.
• Mount the tire on brushes and fix it in the right
position.
Page 13 of 36 Runzel RZL-830 Fördig © RLC Grupp 2023 (ENG)
1
2
3
4