Installation And Connection; Remedy Of Faults; Maintenance And Cleaning; Protective Measures - Pontec PondoAir Set 1200 LED Gebrauchsanleitung

- EN -

Installation and connection

How to proceed:
 B, C
1. Place the unit and the connected artificial water lily into the water.
– The artificial water lily floats on the surface of the water.
2. Route the connection cable to the socket.
– Switching on: Connect the connection cable to the mains. The LEDs in the float will light up, the pump will start
operating.
– Switching off: Disconnect the connection cable from the mains.
3. Set the desired bubbling intensity.
– To increase the bubbling intensity: Turn the valve knob clockwise.
– To reduce the bubbling intensity: Turn the valve knob counterclockwise.

Remedy of faults

Malfunction
LEDs are not lit
Insufficient bubbling intensity.
Insufficient or no pump delivery.

Maintenance and cleaning

The unit has to be taken out of the water for cleaning or maintenance.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

 Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
 Isolate the unit before starting any work.
 Secure the unit to prevent unintentional switching on.
Cleaning the unit
Note!
Recommendation on regular cleaning:
 Clean the pump as required but at least twice a year.
 Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
 Recommended cleaning agent for removing stubborn limescale deposits:
– Vinegar- and chlorine-free household cleaning agent.
 After cleaning, thoroughly rinse all parts in clean water.
10
Cause
No mains connection
Connection defective
Valve soiled
Air hose kinked or porous
The pump filter housing is soiled.
The impeller unit is blocked.
The impeller unit is worn.
Remedy
Connect the connection cable to the mains.
Check the electrical connection.
Clean the valve.
Replace the air hose.
Clean the pump filter housing.
Clean the pump.
Replace the impeller unit.