Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Changing the cutting wheel:
For clamping and loosening the cutting tools, lock the grinder spindle with the
spindle lock button (B). Actuate the spindle lock button only when the grinder
spindle is at a standstill. Otherwise, the machine may become damaged. With
this button depressed rotate the wheel until it has profoundly gone deeper.
The flange (D) can be detached using the supplied wrench (F).
Unscrew the flange completely from the spindle.
Now detach the cutting disc from the machine mount a new disc.
The diamond cutting disc must always be mounted between the two
clamping discs!
Screw the flange (D) onto the spindle and tighten it with the help of the
assembly tool (F) whilst actuating the spindle lock at the same time.
When using diamond cutting discs, pay attention that the direction-of-rotation
arrow on the diamond cutting disc and the direction of rotation of the machine
(see direction-of-rotation arrow on the machine head) agree.
In order to check whether the spindle stop is released before you switch
on the tool, turn the spindle slightly. Check grinding tools before using.
The grinding tool must be mounted properly and be able to move freely.
Carry out a test run for at least one minute with no load. Do not use
damaged, out-of-centre or vibrating grinding tools. Damaged grinding tools
can burst and cause injuries.
Cutting depth limiting
Cut depth adjustment and limiting is available as optional accessories.
Installation and adjustment:
First, remove the protective plate of
the protective cover and replace it by
the protective plate belonging to the
cutting depth limiting.
Use the two wing bolts to tighten the
cutting depth limiting to the protective
plate (refer to the figure).
To set the desired cutting depth,
loosen the two wing bolts, set the
desired cutting depth and tighten the
screws again by hand.
Always check the set cutting depth
by means of a test cut!
24
Werbung
