Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FILLING RESERVOIR
10
•
Place the unit on a flat, stable surface which must not be tilted more than 10° (see drawing)
•
Fill the tank up to the marking with a good quality bubble fluid (order nr.160.575).
•
Switch the unit on via the On/Off switch on the rear side.
Switch the unit off after use and unplug it from the mains if it will not be used for a long period of time.
•
•
Rinse the unit regularly with clean water.
OPERATION
Once the reservoir has been filled. Connect the power lead into smoke machine and earthed mains outlet. Then you can switch
the power on, the machine start producing bubble.
Switch off when machine not used and unplug from mains if not use for long periods.
Left switch
= Remote on/off
Right switch
= Manual on/off
REMOTE
A = On
B = No function
C = Off
D = No function
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality bubble fluid, specially designed for Beamz bubble machines guarantees a trouble-free use with a lot of bubbles.
5 liter packaging, ref. no. 160.574
1 liter packaging, ref. no. 160.575
Before filling unplug from mains!
PLEASE DON'T FILL OVER THE LINE!
= OFF
0
= ON
I
10
10
10
Werbung
Inhaltsverzeichnis
