Setting The Milling Depth - Westfalia WOF 1600 Originalanleitung

5. Run machine up to full no load speed before using and watch out for
vibration or wobbling that could indicate unbal-ance.

Setting the Milling Depth

1. Place the router onto the work-piece.
2. Set the stepped depth control stop (9) to the
lowest step by rotating it.
3. Loosen the retaining lever (14) and slowly
push the machine downwards until the milling
cutter touches the work-piece.
4. Establish and note the value on the depth
scale on the depth check (15) against the index
mark on the machine casing.
5. Move the router to the edge of the work-piece
so that the milling cutter is just overhanging
the work piece and can be pushed further down.
6. Again slowly push downwards until the scale is equal to desired milling
depth minus the previously noted value.
7. Secure the stepped depth check (15) with the wing screw (11).
8. Release the machine and it will rise to its normal rest position.
Milling
1. Place the machine on work-piece and
switch on.
2. Slowly push the machine down until the
depth control stop makes contact.
3. Mill out groove with continuous even feed.
4. When the milling process is complete, raise
the machine and switch off.
Milling with the stepped Control Stop
1. When deeper milling depth is required, it is
recommended to carry out the milling
process in two or three steps.
16