Klarstein 10009786 Bedienungsanleitung Seite 19

How to use the Charging dock station:
There are 5 buttons as shown in the figure below, including: power switch "
Clock button " ", timing button "
During the process a setting, the power switch have the function of
Connect the power socket on the dock station with external power supply, and then press the power
button " " to start the charging station (power on), the base will enter the LCD detection status and
show all content of the LCD as shown in the figure below:
The auto charging dock station have no the memory function ; if it's
power off , all setting will be Cancelled and return to the default
1. Time setting:
In normal operation status, press the clock button "
to switch between settings of minutes and hours, the current value of the selected item being set will
flash, by using this button, you can set the standard time. Press the adjusting button "+" to adjust
minutes, and hours. After time setting finished , then press the full-go button "
values, if no button were pressed within 30 seconds, the base will quit the setting status without save
the values .
Press the power switch button "
2. Weekday setting:
After finishing settings of Hour and Minute. Entering setting for Weekday. Press "+" key to select the
day of week. When a certain day is selected the corresponding day logo will flash for 5 seconds then
stop which indicates this day has been selected. If you don´t want to choose this day press the „+" key
again wwhen it is flashing, then it will go to selection process of the next day. Selection can be made for
consecutive 7 days, or one or several days in one week. Press "
working mode. If weekday setting is not selected, the machine will work every day as default setting. 3.
Timing clean setting :
In normal operation status, press the timing button "
once to switch between settings of minutes and hours, the current value of the selected item being set
will flash, by using this button, you can set the standard time. Press the adjusting button "+" to adjuster
minutes, and hours. After timing clean setting finished , then press the full-go button "
setting values, if no button were pressed within 30 seconds, the base will quit the setting status without
save the values .
" adjusting button "+"
"cancel" and the Full-go button have the function of "confirm".
the time setting status without saving the timing value.
" to enter the time setting status; press once
" or timing button "
" to save setting and return to normal
" to enter the timing clean setting status; press
", Full-go button "
" to save the setting
" will quit
" to save the
19
",