Husqvarna PG 510 Bedienungsanweisung Seite 9

1. Loosen the lock knobs (A) and adjust the handle (B)
to idle position.
A
B
2. Tighten the lock knobs to set the position.
3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
1146 - 002 - 09.12.2022
1. Remove the lock knobs (A) to loosen the support
A
2. Hold the handlebar to keep the frame stable and lift
A
B
foot (B).
A
B
the support foot out and up.
9