Viessmann 6333 Bedienungsanleitung Seite 4

1.3 Checking the package contents
Check the contents of the package for completeness:
- Floodlight spot with connection cables, resistor and diode
- Manual
2. Introduction
This spot produces the light by SMD-LEDs which is suitable to the
lamp model. Low heat build-up and power input. Nearly unlimited
lifetime of the LED, so no more change is required.
3. Mounting
- Remove the spot carefully from the package.
- Check the function before mounting.
- Drill a hole (Ø 2 mm) at the mounting place (see fig. 1).
- Put the cables from outside through the hole and fix the
bracket, e. g. with a commercial glue.
4. Connection
Caution:
Resistor and diode at the cables are needed for proper
function of the lamp. Never cut them off!
Never cover the resistor with insulation material, because it
has to be cooled by surrounding air!
Connect the LED-spot to the light output of a model train
transformer (e. g. item-No. 5200) or power supply as shown in
fig. 3 and/or 4.
DC voltage: Connect the diode (red part with black marking) with
the positive pole and the resistor with the negative pole of the
power supply.
AC voltage: Operation with AC voltage could cause some flickering.
We recommend to use the Viessmann power module, item-No.
5215, which is sufficient for approx. 100 LED-lamps or -reflectors
(fig. 4). Connect the cable with the diode to the brown output socket
and the cable with the resistor to the red output socket.
5. Warranty
Each model is tested to its full functionality prior to delivery.
The warranty period is 2 years starting from the date of pur-
chase. Should a fault occur during this period please contact
our service department (service@viessmann-modell.com).
Please send the item to the Viessmann service department for
checking and repair only after consultation. If we find a materi-
al or production fault to be the cause of the failure the item will
be repaired free of charge or replaced. Expressively excluded
from any warranty claims and liability are damages of the item
and consequential damages due to inappropriate handling,
disregarding the instructions of this manual, inappropriate use
of the model, unauthorized disassembling, construction modifi-
cations and use of force, overheating and similar.
6. Technical data
Operating voltage:
Operating current:
Subject to change without prior notice. No liability for mistakes
and printing errors.
The latest version of the manual can be looked up at the
Viessmann homepage using the item-No.
4
(with and without 5215 power module)
Do not dispose this product through
(unsorted) general trash, but supply it to the
recycling.
Viessmann
Modelltechnik GmbH
Bahnhofstraße 2a
D - 35116 Hatzfeld-Reddighausen
www.viessmann-modell.de
10 – 16 V AC ~
14 – 24 V DC =
13 – 24 V digital signal
ca. 10 mA
Made in Europe
92357
Stand 02/sw
08/2017
Ho/Pic/Me