Westfalia WABHBL18 Originalanleitung Seite 17

▪ Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal
injury.
▪ Hold power tool by insulated gripping surfaces, when performing an operation where
the cutting accessory may contact hidden wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed metal parts of the power tool "Live" and
could give the operator an electric shock.
▪ Battery chargers are for indoors use only. Ensure that the power supply and charger are
protected against moisture at all times.
▪ When using the rotary hammer use safety equipment including safety glasses and ear
protection. Wear respiratory protection suitable for the work being undertaken. If
operating the tool causes discomfort in any way, stop immediately and review your
method of use.
▪ Use metal and voltage detectors to locate concealed electric, water or gas lines. Avoid
touching live components or conductors.
▪ Ensure that the lighting is adequate.
▪ Ensure that the drill bit is securely fixed in the chuck. Insecure drill bits can be ejected
from the machine causing a hazard
▪ Ensure that the drill bit is not in contact with the workpiece prior to starting up the tool.
▪ Before drilling, check that there is sufficient clearance for the drill bit under the
workpiece.
▪ Do not exert pressure on to the tool. To do so would shorten its service life.
▪ Drill bits get hot during operation, allow to cool prior to handling them.
▪ Never use your hands to remove sawdust, chips or waste close by the bit.
▪ If you are interrupted when operating the rotary hammer, complete the process and
switch off before looking up.
▪ Where possible, use clamps or a vice to hold your work.
▪ Examine the chuck regularly for signs of wear or damage. Have damaged parts repaired
by a qualified service centre
▪ Always wait until the drill has come to a complete stop before putting it down.
▪ Periodically check all nuts, bolts and other fixings and tighten where necessary.
Additional Battery and Charger Safety Notes
▪ WARNING: Li-Ion batteries, if incorrectly used, stored or charged are a fire, burn and
explosion hazard.
Use the battery charger correctly
▪ Refer to the section of this manual relating to use of the battery charger before
attempting to charge the battery.
▪ Do not attempt to use the charger with other batteries. Keep the battery charger clean;
Foreign objects and dirt can cause a short circuit and block the ventilation holes. Failure
to follow these instructions may result in overheating or fire.
▪ Allow batteries to cool for 15 minutes after charging or heavy use. Failure to follow these
instructions may cause overheating or fire.
17