Steam Ironing - Silvercrest SDBSB 3000 A1 Bedienungsanleitung

4) The heat-up indicator lamp
up indicator lamp
you can start ironing.
5) After ironing, place the iron on the stand
the tip of the iron under the edge at the front of the stand
the iron completely onto the stand
1 1
Fig. 8
6) Set the temperature control
7) Press the On/Off button
The On/Off control lamp
8) Pull the plug out of the mains socket.

Steam ironing

1) Press the On/Off button
lamp
2) Turn the temperature control
perature control
3) The heat-up indicator lamp
temperature has been reached, the heat-up indicator lamp
4) Press the
–
If the steam control lamp high
produced.
–
If the steam control lamp medium
steam is produced.
–
If the steam control lamp low
steam is produced.
As soon as the steam control lamp high
on the setting) lights up constantly, you can start steam ironing.
■ 14 │ GB │ IE
1
1
goes out, the set temperature has been reached and
e
r
e
r
lights up blue and the steam control lamp low
3
must be set within the
1
‒
+
o
or the button
lights up during heating. As soon as the heat-
6
of the base station. First guide
6
(see fig. 8).
2 2
3
to min.
for about 2 seconds to switch on the appliance.
and the steam control lamp low
to switch on the appliance. The On/Off control
3
to the desired ironing temperature. The tem-
range to produce steam.
lights up during heating. As soon as the set
p
to set the desired steam strength:
z
lights up, a large quantity of steam is
u
lights up, a medium quantity of
i
lights up, only a small quantity of
z
/medium
6
and then place
i
go out.
i
flashes blue.
1
goes out.
u i
/low (depending
SDBSB 3000 A1