Inserting/Replacing The Chisel; Operation; Maintenance And Cleaning - Parkside PDMH 4500 B5 Originalbetriebsanleitung

Inserting/replacing the chisel

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply before
changing tools.
♦ Fit the required chisel
holder 4 of the air hammer.
Then slide the tension spring 6 over the
♦
chisel .
5a 5b 5c
Screw the tension spring 6 onto the thread 1
♦
until it stops. When doing so, hold the tension
spring 6 by the front retaining clip
♦ To change the chisel
tension spring 6 from the cylinder of the air
hammer by holding it by the rear clip
Chisel types
There are three different types of chisels
supplied for different purposes:
- Flat chisel : Use this chisel, for example, to
5a
remove protruding concrete or mortar residue.
- Cutting chisel (sheet metal chisel): Use this
5b
chisel, for example, to cut sheet metal.
- Pointed chisel : Use this chisel, for example, to
5c
break up, break through and break off masonry
and stone.

Operation

♦ Align the appliance with the area to be
machined.
Press the trigger 3 to switch the appliance on.
♦
Release the trigger 3 to turn off the appliance.
♦
♦ When you have finished working, disconnect
the appliance from the compressed air source.
│ GB │ IE
■ 8
into the tool
5a 5b 5c
.
6a
, unscrew the
5a 5b 5c
.
6b
5a 5b 5c

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working process-
es) have accumulated on the appliance. Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis.
► The dust and vapours produced by using the
appliance can be hazardous to health (e.g.
cause cancer, birth defects, asthma and/or
dermatitis); it is essential to carry out a risk as-
sessment in respect of these risks and to imple-
ment corresponding regulatory mechanisms.
NOTE
► The following points must be observed to en-
sure that the compressed air tool functions cor-
rectly and has a long service life:
■ Before each use, check the tool and the insert
tool, including a check of the speed and vibra-
tion level.
■ After each use, check the speed and vibration
level of the tool. During maintenance work,
please ensure that appropriate protective cloth-
ing (ear muffs, dust mask, protective goggles
and protective gloves) is worn.
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at danger. In doubt, contact the
Service Centre.
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer.
■ Only clean the appliance with a soft, dry cloth
or with compressed air.
■ Never use sharp or abrasive cleaning agents
under any circumstances.
PDMH 4500 B5