Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Operation
Adjusting the impact force
The impact force is set with the adjusting wheel (2). When viewed from the
rear, turn the wheel clockwise to increase the impact force and
counterclockwise to decrease the impact force. Also note the symbols. See also
Fig. A1 and A2.
Loading the Magazine
Press the release switch (3) and pull the magazine housing down and out. Place
the strip of nails or staples on or over the magazine rib as shown in the picture.
Then slide the magazine housing back on. If necessary, press the strip of nails
or staples against the magazine rib.
Setting Nails and Staples
Connect the device to a 4 - 7 bar compressed air supply. If possible, use a
maintenance unit that removes the water from the compressed air and adds an
oil mist. See picture (C).
Place the device on the tool at the desired location and press it against the
surface. The safety slide (4) must be fully pressed in. Then press the trigger (1)
to drive the nail or staple.
You can regulate the direction of the exhaust air by turning the blower (5).
Removing Jammed Clamps
Disconnect the device from the air supply. Fold the locking lever (6) up and
open the tool head. Remove the jammed staple or nail. See also Fig. B1 and B2.
8
Werbung
Inhaltsverzeichnis
