Inserting/Changing The Batteries - Bosch AdvancedTemp Originalbetriebsanleitung

28 | English
Thermo detector
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
A) At a measuring distance of 0.75–1.25 m from the surface
B) At an ambient temperature of 21–25 °C
C) At a measuring distance of 0.1–0.3 m from the surface
D) Values in accordance with the Association of German Engineers' VDI/VDE 3511 part 4.3 stand-
ard (publication date July 2005); applies for 90 % of the measuring signal.
In all areas beyond the values detailed in the technical data, deviations are possible in measure-
ment readings.
E) Refers to infrared measurement, see figure:
0,18 m
F) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number (7) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
To open the battery compartment cover (9), press the locking mechanism (10) and lift
open the battery compartment cover. Insert the batteries. When inserting the batteries,
ensure the polarity is correct according to the representation on the inside of the battery
compartment cover.
The battery indicator (g) shows the state of charge of the batteries:
Display
1 609 92A 7M8 | (03.05.2022)
1 m
Capacity
76 % to 100 %
AdvancedTemp
0.28 kg
124 × 53 × 180 mm
Bosch Power Tools