Storage - Silvercrest 359294 2010 Montage-, Bedienungs- Und Sicherheitshinweise

Do not use solvents, petrol, etc.
These would damage the
product.
Empty the dust collector
(see chapter "Emptying the dust collector")
and thoroughly tap it out.
Cleaning the surface of the product:
When cleaning the surfaces, e.g. of the main
unit , rechargeable battery
4
floor brush
, use a feather duster or soft,
14
slightly moistened cloth for persistent dirt.
Cleaning the accessories:
Regularly remove any hair and dirt from the
accessory parts.
Clean the crevice nozzle
and the brush under running water. Allow
11
all accessory parts to dry thoroughly before
using or storing them again.
Cleaning the rotating brush roller:
Remove the electric floor brush
aluminium suction tube
release button on the aluminium suction
15
tube and remove the electric floor brush
16
Turn the electric floor brush
Use a flat-tip screwdriver to turn the fixing screw
of the locking mechanism
14 c
wise towards the
14
14 a
14c
14b
Carefully fold up the locking mechanism
before cleaning
21
or electric
2
, the dust brush
13
from the
14
. To do so, press the
16
14
around.
14
anticlock-
14 b
- symbol.
14 b
and then remove the rotating brush roller
from the housing of the electric floor brush
14b
Clean the rotating brush roller
12
any hair or dirt.
Also remove any dirt from the housing of the
electric floor brush
Then replace the rotating brush roller
the housing of the electric floor brush
Then carefully press the locking mechanism
down again.
14 b
Attach the rotating brush roller
. the fixing screw
clockwise in the direction of the
Check that it is positioned correctly.

Storage

Disconnect the power supply if
the product will not be used for
an extended period.
Remove the rechargeable battery
from the holder in the handle
2
of the main unit
1
ter "Charging the rechargeable
battery") and store it outside of
the main unit
14 a
by removing
14 a
.
14
14 a
14
by turning
14 a
using a flat-tip screwdriver
14 c
- symbol.
(see chap-
4
.
4
GB/IE/NI/CY
14 a
.
14
in
.
21