Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Measuring the depth of a drill hole
4. Remove the depth measuring tip
depth measuring tip holder
measuring tip into the back at the lower end of
the scale
.
[
1 ]
5. Slide down the product to the lower end of the
scale
.
1 ]
[
6. Select the desired measurement mode with the
measuring mode toggle button
7. Perform the measurements.
8. Read the measuring values on the LC
display
(Fig. D).
10 ]
[
9. Switch off the product: Press and hold the on/
off button
for approx. 2 seconds.
[
9 ]
from the
[
7 ]
. Insert the depth
6 ]
[
.
5 ]
[
˜ Switch the measuring mode
NOTES:
ABS mode: The displayed measuring value
is the absolute value. The reading is set to 0
when pressing the on/off button
When measurement mode is switched from
ABS to INC, the displayed value is set to 0.
The displayed measuring value is the relative
value (Fig. E).
Briefly press the measuring mode toggle
button
to select the desired measurement
5 ]
[
mode ABS or INC. The selected mode is
indicated on the LC display
.
9 ]
[
.
10 ]
[
GB
15
Werbung
Inhaltsverzeichnis
