Bosch AdvancedGrassCut 36 Originalbetriebsanleitung Seite 19

Lawn trimming/Edge cutting
Press button (12). Turn the bottom part of the trimmer by
180° to position the trimmer head either for lawn trimming
or edge cutting. Release button (12) so that the turning
mechanism engages.
Lawn trimming
Move the trimmer left and right, keeping it well away from
the body. Cut higher grass in steps. (see figure G)
Edge cutting
Guide the trimmer along the edge of the lawn. Avoid contact
with solid surfaces or walls to prevent rapid wear of the cut-
ting line. (see figure H)
Cutting around trees and bushes
For better control, use the plant protector (8). Carefully cut
around trees and bushes so that they do not come into con-
tact with the cutting line. Plants can die if you damage the
bark.
Dismounting the spool, winding up the cutting
line and mounting the spool (see figures I bis L)
Remove the battery before replacing the spool.
u
Troubleshooting
Lawn Trimmer/Lawn Edge Trimmer
Problem Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Garden tool functions On/Off switch defective
intermittently
Internal wiring of garden tool defective
Garden product la- Grass too high
bours
Garden tool does not Cutting line too short/broken off
cut
Spool empty
Cutting line can no Line inside the spool entangled
longer be fed
Spool empty
Cutting line retracts Cutting line too short/broken off
into spool
Cutting line breaks fre- Line inside the spool entangled
quently
Trimmer used incorrectly
Heavy vibrations Cutting line broken
Cutting system damaged
Grass between spool housing and line-feed but-
ton
Bosch Power Tools
Press both latches of the spool cover together and remove
the spool cover (13). Afterwards, remove the empty spool
(14).
Cut off approx. 6.0 m line from the refill roll. Fold the line in
half, so that it has a length of 2 x 3 m. Attach the line centre
to the nose on the spool and wind up the line - one end in
each spool compartment - uniformly distributed and taut.
Slide both ends of the cutting line through the holes for line
guiding (15) in the trimmer head and mount the spool back
into the trimmer head. Affix the spool by mounting the spool
cover (13).
Line Feeding (see figure M)
Semi-automatic Line Feeding
The trimmer is equipped with a semi-automatic feeding sys-
tem. The system feeds 10 mm of the line with every press of
the on/off switch (2).
Manual Line Feeding
Press the line-feed button (16), and pull the cutting line out
to the desired length.
Corrective Action
Recharge battery
Allow to cool/warm
Contact Bosch customer service agent
Contact Bosch customer service agent
Cut in stages
Manually feed cutting line
Replace line spool
Inspect the spool, rewind if necessary
Refill line spool
Remove spool – rethread line (see figures J − L)
Remove spool – rewind line (see figures J − L)
Only trim with the tip of the line, avoid stones,
walls and other hard objects. Feed the line regu-
larly to maintain full cutting diameter.
Pull out cutting line with manual feed (see figure
M)
Contact Bosch customer service agent
Disassemble spool cover and remove grass
English | 19
F 016 L94 427 | (17.05.2022)