Siemens SIMATIC NET Industrial Ethernet FastConnect RJ45 Plug 145 Montageanleitung

Assembly Instructions for SIMATIC NET Industrial Ethernet FastConnect RJ45 Plug 145
green
1. Use the green knife cassette
6GK1901-1GB01 (5.1 mm knife clearance)
in the stripping tool.
If your stripping tool was supplied with a
yellow knife cassette, the cutting depth must
be adjusted with the middle socket-head
screw after fitting the new cassette!
6. To strip the insulation, turn the tool in the
direction of the arrow
- approx. 4 times for PVC insulation,
- approx, 8 times for PUR insulation.
18
5
10. Spread out the wires according to the
color markings on the contact elements of
the FC RJ45 plug.
11. Make sure to observe a length of
approximately 18 mm.
14. Move the cable jacket forward to the limit
stop.
15. Turn the locking mechanism with open
side pointing to the cable and close the
cover.
16. Make sure the cable shield is connected
to the shield contacts and the jacket to
the strain relief mandrel of the plug.
Replace the knife cassette if the cut edges
become ragged or after approx.·
· 1500 operations on cables with PVC outer
jackets·
· 150 operations on cables with PUR
outer jackets
When using devices without a securing collar, make sure to provide strain relief for the cable as closely as possible to the device.
You will find information on network structures in the SIMATIC NET Industrial Ethernet Networking Manual
Copyright © 2017 Siemens AG
36mm
2. Take the stripping tool in your right hand.
3. Measure the cable length against the
measuring template. Use your left index
finger as the limit stop.
7. Keeping the stripping tool closed, pull it off
the end of the cable along with the jacket
and remnants of the shield.
12. Open the holder cover until it latches and
push in the wires according to their color
coding* as far as the limit stop in the
holder cover.
o
90
17. Close the cover by pressing together the
two halves of the lock. In doing so, make
sure not to exert pressure on or damage
the latch spring.
Turn the locking mechanism with your
hand as far as possible in the direction
of the arrow.
The piercing contacts of the FC RJ45 plug
can be released and recontacted up to 10
times. Cable ends that have already been
pierced must not be used again but must be
cut off.
Don't pull while unlocking the plug.
6GK1901-1BB30-0A..
4. Insert the cable into the stripping tool. Your
left index finger is the limit stop.
5. Tighten the stripping tool fully.
8. If the white filler is not removed with the
insulation, remove it and the transparent
protective foil with your hand.
9. Cut off the dummy cores.
13. Press down the contact elements as far
as the limit stop to contact the wires.
18. Insert the plug into the socket and push
the spring down to unlock the plug and
release it from the socket again.
If space is limited, release the plug
using a screwdriver (2.5 mm-wide
blade).
To create a crossover cable, combine the
wires in the connector at one end according
to the following scheme:
Connect white with yellow
Connect blue with orange.