Assembly Instructions - Bosch Rexroth SM24V+ Bedienungsanleitung

10/36 Bosch Rexroth AG

4 Assembly Instructions

Unqualified repairs or operations on the hard-
ware or software or the failure to observe the
warnings in these instructions or warnings
placed on the product itself could lead to per-
sonal injury or damage to equipment.
Qualified personnel are:
– Project personnel, familiar with the safety
regulations of automation systems and
electrical engineering.
– Operators, instructed in the use of the
equipment and having knowledge of the
relevant operational parts of this docu-
mentation.
– Commissioning personnel, authorized
to set electric circuits and machines/sys-
tems into operation, ground and mark
them, according to the accepted rules of
safety and current technology.
Repairs and replacement of parts carried out
by the user are his own responsibility. After
repairing or replacing parts, all prescribed
functional and safety checks must be carried
out.
SM24V+ | 3 609 929 A21/06.02
4 Assembly Instructions
The module is inserted into the system com-
ponents SE3x2/SEH3x2/KE3xx.
3 Min
Take care that the interface module is com-
pletely inserted.
The front knurled bolts must be tightened.
Take care that the front panel fits flush with
the SE3x2/SEH3x2 or KE3xx while tighten-
ing the knurled bolts.
Before inserting the
Rexroth interface mod-
ules, the BT300 card
rack or the SB301/
SB305/SBH301 sys-
tem boxes must have
been voltage-free for
at least 3 minutes.