Turning on the product
Connect the power plug
socket-outlet.
Activating the standby mode: Set the on/off
18 ]
[
to I . A short beep sounds . The
switch
[
6 ]
display
shows the room temperature
and the
timer indicator
Turning on the product: Press
product switches to fan mode .
NOTE: When the product is in operation, the
[
11 ]
control lamp
is lit .
Turning off the product
Switching to standby mode: Press
NOTE: The fan continues to run for about
another 4 to 5 seconds . Afterwards, the
product turns off and the control lamp
out .
Turning off the product fully: Set the on/off
18 ]
[
to 0 .
switch
Control panel / Remote control
Press the buttons on the control panel
use the remote control
NOTE: In standby mode, no settings can be
made . First, switch on the product by pressing
8 ]
[
[
23 ]
.
Button
Setting
3 ]
[
[
22 ]
Timer
[
4 ]
[
25 ]
Swivel function
[
5 ]
24 ]
[
Operating mode
7 ]
[
27 ]
[
Increase value
8 ]
[
[
23 ]
Standby/operation
[
9 ]
26 ]
[
Decrease value
14 GB
19 ]
[
to a suitable
31 ]
[
30 ]
[
0:00 flashes .
[
8 ]
23 ]
[
. The
8 ]
[
23 ]
[
.
[
11 ]
goes
[
1 ]
or
[
20 ]
to make settings:
Selecting an operating mode
Switching the mode: Repeatedly press
[
5 ]
[
24 ]
until the desired operating mode
[
29 ]
indicator
is shown in the display
Display Operating mode
Fan
In fan mode, no heating level is
activated .
Half heating level
50 % heating power
Full heating level
100 % heating power
Automatic heating level
The product automatically adjusts
the heating level to the ambient
temperature .
Frost protection
At room temperature under
+6 °C, the product turns on
automatically .
The product heats the room
until the temperature exceeds
+12 °C .
At a temperature of +12 °C, the
product turns off automatically .
NOTES:
Whether heating level
appropriate selection, depends on the room
size . We recommend first operating the
product on heating level
level
if the heat output on heating level
not sufficient .
The operation mode is memorized when the
product is switched to standby mode . When
the product is switched on again, the previous
operation mode will be recalled .
6 ]
[
:
or
is the
. . Switch to heating
is