System Requirements - Velleman CAMCOLVC26N Bedienungsanleitung

Move slowly from one side of the observed area to the other. Move parallel
to the camera and try out different angles and distances.
The red LED [L] indicates that you were detected by the PIR sensor zone.
In order to prevent incorrect signals and unnecessary photos, we
recommend not using the camera at sunny points and check that no
branches are in the active area of the sensor. Optimum alignment is in
North or South direction. The detection range of the sensor is approximately
60°.
Also, check that the camera is installed at the correct height in line with the
point to be observed. When necessary, point the camera down for optimum
alignment.
Note
This camera corresponds to protection class IP54. It is protected against
dust and spray, and can thus be used in any weather condition.
7.7 File Format
The camera stores photos and videos on the memory card in the folder
\DCIM\100MEDIA.
Photos are given extension JPG, videos are given extension AVI.

8. System Requirements

Connect the camera to your computer using the included USB cable.
System Requirements
Windows ®
 Pentium ® III or higher
 Windows ® XP/Vista/7/8
 512 MB RAM
 1 GB available hard disk space
 Screen resolution 1024x768
or higher
 Available USB connection
V. 02 – 26/09/2018
CAMCOLVC26N
Mac ®
 PowerPC G3/G4/G5
 OS 10.3.9 or newer system
 512 MB RAM
 1 GB available hard disk space
 Screen resolution 1024x768
or higher
 Available USB connection
14 ©Velleman nv