Intended Use; Start-Up; Laser - Westfalia MNF1700 Originalanleitung

Intended Use

 The wall router cuts slots for cables and pipes in all kinds of brickwork and
concrete, provided that suitable cutting discs, as described in this manual, are
used.
 The machine is suitable for dry cutting only.
 This machine has been developed for private use and is not designed for the
demands of industrial use.

Start-Up

 Make sure that the mains voltage corresponds to the rated voltage of this
machine. Units rated with 230 V also can be used with 220 V power networks
and vice versa.
 Before connecting the machine to mains power, make sure that it is switch off
to prevent unintentional starting.
 Press the unlocking button (12) and then operate the ON/OFF switch (3) to
turn on the machine. An electronic device starts the machine slowly (soft start).
The machine must have reached full speed before you can start cutting.

Laser

The machine is equipped with a laser, which makes guiding the machine easier.
With the switch (16) you can turn the laser on and off.
The laser is operated with two batteries LR03 (AAA). Open the battery
compartment to change the batteries. Please observe correct polarity and only
use batteries of the same type and charging state.
Inbetriebnahme
15
3
12