Removing The System From The Rack; Installing The Cable-Management Arm - Dell HT118 Installationsanleitung

Removing the System From the Rack

To remove the system from the rack, perform the following procedure:
1 Turn off the system and attached peripherals, and disconnect the system
2 Remove the I/O cable connectors and power cable connectors from
3 Loosen the thumbscrews on each side of the front chassis panel
4 Pull the system out of the rack until it stops because of the safety catch.
5 Pull up on the front release latch on each rail to disengage the safety catch
6 Pull the system completely out of the rack.

Installing the Cable-Management Arm

1 Fit the latch on the front end of the cable-management arm onto
2 Fit the latch on the unattached end of the cable-management arm
Downloaded from www.Manualslib.com
from the electrical outlet.
their respective connectors on the system back panel.
that secures the system to the rack.
(see Figure 1-7) and slide the system forward.
NOTE:
Follow the steps for installing a Cable-Management Arm (CMA) if you
ordered a CMA with your system. If you did not order a CMA, Dell recommends that
you retain the documentation for installing this feature in the event that you choose
to order a CMA at a later time.
NOTE:
You can attach the cable-management arm to either side of the rack cabinet.
NOTE:
Attach the cable-management arm ramp assembly to the side opposite
of where you attach the cable-management arm.
the bracket on the end of the mounting rail until the latch clicks
(see Figure 1-8).
onto the bracket on the end of the slide assembly until the latch clicks
(see Figure 1-8).
CAUTION:
Both ends of the cable-management arm must be connected before
you begin routing the system cables.
manuals search engine
Rack Installation Guide
19