Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling; Battery Disposal - EINHELL 9-13 Originalbetriebsanleitung

6.6 Setting the safety level (Fig. 1)
The safety level controller (4) enables you to
adjust the safety level to the welding method and
welding current you wish to use. A table with the
recommended values for this purpose is provided
in point 10.2.
7. Cleaning, maintenance and
ordering of spare parts
7.1 Cleaning
•
Keep the automatic welding screen free of
dirt and dust as far as possible. Rub the de-
vice with a clean cloth or use a slightly damp
cloth and a little lubricating soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the appliance.
•
We recommend that you clean the appliance
immediately after you use it.
•
Ensure that no water can get into the interior
of the tool.
7.2 Cleaning the fabric cover on the front
headband (Figure 7)
The front headband (Item 10) can be removed
for cleaning. Remove the two plastic buttons from
the appropriate openings and remove the front
headband as shown in Figure 7. Clean the front
headband (Item 10) with a little lubricating soap
under running water.
7.3 Servicing
Dispose of soiled maintenance material and ope-
rating materials at the appropriate collection point.
7.4 Replacing the safety screen (Fig. 8-9/Item
2)
There is a trough handle below the safety screen.
To remove the safety screen glass, reach into this
and remove the safety screen (Item 2) forwards.
To insert the new safety screen, push it together
slightly and press it behind the four retaining pins
(Item G).
The safety screen is made of fl exible material and
can easily be bent, but do not kink it.
7.5 Storage
Store the device in a dry place which is not ac-
cessible to unauthorized persons. The storage
temperature range is -20°C to +70°C.
Anl_Automatik_Schweissschirm_9_13_SPK9.indb 20 Anl_Automatik_Schweissschirm_9_13_SPK9.indb 20
GB
7.6 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.

9. Battery disposal

Batteries contain materials that are potentially
harmful to the environment. Never place batteries
in your household refuse, in fi re or in water. Bat-
teries should be collected, recycled or disposed
of by environment-friendly means. Send your
old batteries to ISC GmbH, Eschenstrasse 6 in
D-94405 Landau. You can then be sure that the
equipment will be correctly disposed of by the
manufacturer.
- 20 -
!
19.08.2019 08:27:08 19.08.2019 08:27:08