Automatic Tuning; Factory Default - Hama FTA Benutzerhandbuch

AUTOMATIC TUNING

In this menu, you can do an Automatic tuning
with enter the start, stop frequency and the
polarization with maximum 3 different Symbol
Rate setting.
Press OK button any time to go to the auto-
matic tuning process, CH Search Process
window will appear. Confirm to store all
searched channels by press OK or EXIT
button to exit without storing the channel.
Then, it will search all found carriers one by
one.
During the searching (before the COMPLETE
message comes out), you can press MENU
button to by-pass the transponder or EXIT
button to stop & exit.
Confirm to store all searched channels by
press OK or press EXIT button to exit without
storing any searched channel.

FACTORY DEFAULT

Press OK button on the FACTORY DEFAULT of
the INSTALLATION. You can change the
system setup into the default values.
The confirmation pop-up window will appear.
If you select YES, the system setup will be
reset to the factory default values.
It may take about 30 to 45 seconds.
It will display all found digital carriers until
complete the 3 different Symbol Rate with
start & stop frequency one by one.
67