Rear Panel
IF IN (13/18V 500mA Max)
Connect the IF cable from your LNB on your dish to this connector.
IF OUT (Loop Through)
Output port for the IF IN signal. Connect to other receiver.
RS-232
Connect a Receiver or serial port of PC.
ANT IN*
Connect the terrestrial antenna.
RF OUT (UHF Modulator output)*
Connect to the TV set RF IN.
POWER CORD
Connect this to the mains outlet (90-270VAC 50-60Hz) after all other connections have-
been made.
AUDIO OUT (L/R)
Left, Right audio output.
TV SCART
Connect your TV via a SCART cable to this connector.
VCR SCART
Connect your VCR via a SCART cable to this connector.
*(only on modulator version)
49