Herunterladen Inhalt Inhalt Diese Seite drucken

Philips DP6000 Bedienungsanleitung Seite 5

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
INTRODUCTION
The paging receivers are intended for use
in a Philips DP6000 Digital Paging system.
Each receiver is assigned an address and
can alert its holder with the following
during a call:
LED indication (figure 1(3)).
Indicates an incoming call.The LED
flashes during the bleep and for 8
seconds after the bleep.
Audible bleep The receiver can be
called with 1 of 14 different bleep
patterns (7 normal and 7 cricketed
tones; see figure 4)
- The bleep can be RESET using the
RESET/RECALL button (figure 1(10)).
If set for 'Bleep until RESET' and a
RESET is not given within 60 seconds,
the bleep will start again after 30
seconds of silence.This procedure will
continue until RESET or for a
maximum time of 255 seconds.
Vibration (figure 1(4)) Receivers with
vibrator are able to vibrate in unison
with the called bleep pattern (figure
4).To RESET; see audible bleep.
Each paging call can include:
Numeric messages displayed on
the receivers 5-digit display (figure
1(2)). See 'Message Handling'.
1-4
Alphanumeric messages displayed
on the receivers 24 character LC-
display (figure 1(5)) (Type dependent).
See 'Message Handling'.
Telemetry messages (e.g. process
monitoring) displayed on the
receivers numeric and alphanumeric
display. See 'Telemetry Messages'.
Spoken messages (one-way from
central via receiver loudspeaker). See
'SpeechMessages'.
For versions with an alphanumeric display,
an icon display bar (figure 3) shows
highlighted icons to alert the user of events.
Addresses
Each pager has 8 addresses: 1 normal, 5
group, 1 ALL-call and 1 telemetry/normal
address. Calls can be to individuals, or to
individuals included in a group (group call
e.g Fire Team) or to ALL receiver holders in
the system (ALL-call CCCC). A telemetry
address can be used to page 'up-to-date'
telemetry information (e.g process data).
Addresses can be 4 or 7 digits. The
number of address digits displayed depends
on the installer setting of the receiver.
Thiscan be up to 4 digits maximum in the
numeric display and up to 7-digits
maximum in the alphanumeric display. For
1-5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis