Er-Gd61/Er-Gd51; Troubleshooting - Panasonic ER‑GD61 Bedienungsanleitung

Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
(See page 15.)
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
Replacement parts
►
Replacement part is available at your dealer or Service
Centre.
Replacement parts for
ER‑GD61/ER‑GD51
• Do not use any blade other than the one dedicated as
it may cause defect in performance.
• We recommend Panasonic lubrication oil WES003P.
16
PB016970 - ER-GD6151 _(01GB)_12-04-18.indd 16
Blade WER9500
Lubrication oil WES003P

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the
store where you purchased the unit or a service
centre authorized by Panasonic for repair.
Problem
Until problems are solved, please
follow each procedure as follows:
1. Charge the main body.
(See page 11.)
2. Clean the blade and apply oil.
(See pages 14‑16.)
The main body
3. Replace the blade.
has become
(See page 15.)
blunt.
4. Have the battery replaced by an
authorized service centre.
Operating time
is short.
Charge the battery for
approximately 8 hours
Main body
continuously to rejuvenate it.
stopped
If few uses remain even after
functioning.
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)
Contact an authorized service
centre for repair.
Action
2018/12/4 9:33:36