Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same.
CONTENTS
FEATURES ................................................................................. 4
PANEL FACILITIES .................................................................... 7
CONNECTIONS ......................................................................... 9
TROUBLESHOOTING .............................................................. 14
SPECIFICATIONS .................................................................... 15
The export of this product from Japan is regulated by the
Japanese government. The export of this product may be
prohibited without governmental license. To export or re-
export of this product from a country other than Japan may
also be prohibited without a license from that country.
4
<DRC1091>
En
FEATURES
100-disc storage ... Two 50-disc magazines are
accommodated and each of them can be changed
from the front panel.
Average disc replacement time (from clamp-up to
clamping of next disc) of 5 sec. (Max. time: Below 7
sec.
Mail slot (horizontal tray type) is provided (for use
in disc replacement or use of the Plus One disc).
Control panel is provided (for an offline disc
replacement capability).
SCSI2 interface (for the changer and drive).
SCSI bus terminator.
External SCSI terminal is provided for each drive to
allow system integration for multiple purposes.
Automatic recognition of drive IDs from the changer.
LINE VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on the rear panel of this
changer. Check that it is set properly before plugging the power
cord into the outlet. If the voltage is not properly set or if you move
to an area where the voltage requirements differ, adjust the
selector switch as follows:
÷ Be sure to disconnect the power cord from its outlet before
making this adjustment.
÷ Use a medium-size (flat blade) screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and turn it
so that the arrow points to the power voltage making of your
area.
120V
100V
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet
as this could cause a short circuit or an electric shock. Do not place
the unit, a piece of furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords. The power
cords should be routed such that they are not likely to be stepped on.
A damaged power cord can cause a fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
230V