Inhaltsverzeichnis
Werbung
en
d
Risk of overheating!
Never leave the heating pad unattended
while it is switched on; switch it off before
leaving the room.
Do not cover the thermostat!
To ensure that the thermostat functions
correctly, do not place it on or under the
heating pad or cover it with other objects.
Do not wind the power cord around the
thermostat.
Continuous use at a high heat setting may
cause skin burns.
d
Risk of injury!
The heating pad must not be used by people in
need of help, by persons sensitive to heat or by
toddlers.
Do not allow persons (also children) with re
stricted physical sensory perception or mental
abilities or with lack of experience and know
ledge to operate the applicance unless they are
supervised or have been instructed in the use of
the applicance by somebody who is responsi
ble for their safety.
Keep children away from the applicance to pre
vent them from playing with the applicance.
Parts and controls
Fig. 1
1 Heating pad
2 Fabric cover
3 Thermostat
4 Indicator light
6
Application options
The heating pad is designed for use on the
following body parts: arms, legs, stomach,
shoulder, thigh, calf, etc.
Switching on the
appliance
S
Put the heating pad (1) in the fabric cover (2).
Ensure that the power cord and thermostat
(3) are situated outside the cover (2). Close
the Velcro fastener or zip.
S
Set the required temperature on the
thermostat (3).
Fig. 2
When the temperature is set on the thermostat
(3), the heating pad switches on and the
indicator light (4) comes on.
Fig. 3
If the thermostat (3) is set to position 0",
the heating pad switches off and the indicator
light (4) goes out.
Caution:
When using the heating pad, ensure that a little
air can circulate between the heating pad and
skin. Never use the heating pad without its
fabric cover.
Automatic switch off
To prevent unsupervised operation, the heating
pad automatically switches off after approx.
90 minutes continuous operation. The indicator
light comes on again. To switch on the heating
pad again, first set the thermostat to 0" and
then to the required temperature.
S
After use, pull out the mains plug.
Werbung
Inhaltsverzeichnis
