Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USB Disk Drive Quick Guide
L
Installing the Software
Installation on Windows XP:
Connect the USB disk drive after the com-
puter has been started. The drivers required
are installed automatically.
Important instructions for Windows XP:
Always double-click the "Remove hardware
safely" symbol (symbol with a small green
arrow) in the SYSTRAY (beside the clock) to
remove the drive while the computer is run-
ning. Select the USB disk drive, then click
=> Finish => OK. The following message
appears: Hardware can now be removed =>
OK. The USB disk drive can now be remo-
ved.
You can check whether drive has been
installed successfully by selecting Start =>
Control Panel => System => Hardware =>
Device Manager (in some systems, you
must click Switch to Classic View to see the
System icon).
The following must appear without a yellow
exclamation point:
Disk drives
• MITSUMI USB FDD USB Device or
• TEAC FD-05PUB USB Device
USB controller
• Mitsumi disk drive (USB) or
• TEAC disk drive (USB)
Installation on Windows 2000:
Connect the USB disk drive after the com-
puter has been started. The drivers required
are installed automatically.
Important instructions for Windows 2000:
Always double-click the "Remove or eject
hardware safely" symbol (symbol with a
small green arrow) in the SYSTRAY (beside
the clock) to remove the drive while the
computer is running. Select the USB disk
drive, then click => Deactivate => OK.
"Hardware can now be removed" is display-
ed => OK. The USB disk drive can now be
removed.
You can check whether the drive has been
installed successfully by selecting => Start
=> Settings => Control Panel => System =>
Hardware => Device Manager. The follo-
wing must appear without a yellow excla-
mation point:
Disk drives
• High capacity disk drive
USB controller
• Mitsumi disk drive (USB) or
• TEAC disk drive (USB)
Installation on Windows ME:
Connect the USB disk drive after the com-
puter has been started. The drivers required
are installed automatically.
Werbung
