Optimum Operation - Daikin CONVENI-PACK LRYEQ16AY1 Betriebsanweisung

For example:
When the timer is programmed to stop the sys-
tem after 3 hours and start the system after 4
hours, the system will stop after 3 hours and
start 1 hour later.
5-5 PRECAUTIONS FOR GROUP CON-
TROL SYSTEM OR TWO REMOTE CON-
TROLLER CONTROL SYSTEM
This system provides two other control systems
beside individual control (one remote controller con-
trols one indoor unit) system. Confirm about your
system to Daikin dealer.
• Group control system
One remote controller controls up to 16 indoor
units. All indoor units are equally set.
• Two remote controller control system
Two remote controllers control one indoor unit (in
case of group control system, one group of indoor
units). The unit is individually operated.
NOTE
• Contact your Daikin dealer in case of chang-
ing the combination or setting of group con-
trol and two remote controller control
systems.

6. OPTIMUM OPERATION

Observe the following precautions to ensure the
system operates properly.
• Turn off the power if the unit is not operated for a
long time.
The unit will consume a power of several watts to
several tens of watts if the power is on (see note).
For the purpose of machine protection, however, be
sure to turn on the power at least 6 hours before
resuming the operation of the unit.
Note: The power consumption of the unit varies with
the operating factors, such as the CONVENI-
PACK model.
English
Fig.7
OFF
• Install an alarm if operational errors are likely to
degrade the commodities in storage.
The unit is provided with a terminal to output an
alarm signal.
If the system should malfunction and there is no
alarm, the operation of the unit will be interrupted for
a long time and damage to the commodities in stor-
age may result.
The installation of an alarm is recommended in
order to take appropriate measures promptly in such
cases.
For details, consult your dealer.
• Adjust the air outlet properly and avoid direct air
flow to room inhabitants.
• Adjust the room temperature properly for a com-
fortable environment. Avoid excessive heating or
cooling.
• Prevent direct sunlight from entering a room dur-
ing cooling operation by using curtains or blinds.
• Ventilate often.
Extended use requires special attention to venti-
lation.
• Do not keep doors and windows opened. If the
doors and windows remain open, air will flow out
of your room causing a decrease in the cooling or
heating effect.
• Never place objects near the air inlet or the air
outlet of the unit. It may cause deterioration in the
effect or stop the operation.
• Turn off the main power supply switch to the unit
when the unit is not used for longer periods of
time. If the switch is on, it uses electricity. Before
restarting the unit, turn on the main power supply
switch 6 hours before operation to ensure smooth
running. (Refer to the chapter "Maintenance" in
the indoor unit manual.)
• When the display shows "
air filter), ask a qualified service person to clean
the filters. (Refer to the chapter "Maintenance" in
the indoor unit manual.)
• Keep the indoor unit and remote control at least 1
m away from televisions, radios, stereos, and
other similar equipment.
Failing to do so may cause static or distorted pic-
tures.
• Do not use other heating devices directly beneath
the indoor unit.
If you do, they might get deformed by the heat.
• It takes time for the room temperature to reach the
set temperature.
We recommend starting the operation in advance
using timer operation.
" (time to clean the
9