Alarm Mode - Hama EWS-800 Bedienungsanleitung

• The weather symbols change depending on the current
relative atmospheric pressure and atmospheric pressure
changes within the past six hours. If the weather is
changing, the atmospheric pressure trend arrows (3) flash
for three hours to indicate the change in weather. The
arrows (3) stop flashing when the weather conditions have
subsequently stabilised and the station has not detected
any further changes in weather.
Examples:
Display
• The bar graph (8) shows the history of the relative
atmospheric pressure within the last 24 hours.
6.4. Temperature / atmospheric pressure display
mode
• Press the button (28) repeatedly to change between
SET
the following displays:
• Outdoor temperature (18:
temperature (18:
DEWPOINT
• Absolute atmospheric pressure (7:
atmospheric pressure (7:
The applicable display begins to flash.
• While the display is flashing, press the
(30) or the + button (31) to switch between the outdoor
temperature and the dew point or between the absolute
and relative atmospheric pressure.
• Confirm your display selection by pressing the
(28).
4
Meaning
Weather forecast: Rain
Atmospheric pressure
trend: Decreasing /
Weather is getting worse
Current weather: Cloudy
Current weather: Slightly
cloudy
Atmospheric pressure
trend: Increasing /
Weather is improving
Weather forecast: Sun
)/ Dew point
TEMP
)
)/Relative
abs
)
rel
button
MIN/MAX
button
SET
Note – Dew point
• The dew point temperature indicates a value to which,
with the current humidity level, the outside temperature
would have to increase/decrease in order to reach
100% relative humidity.

6.5 Alarm mode

• Repeatedly press the
ALM
(4/11/16/21) or
LO AL
• In alarm mode (4/11/16/21), repeatedly press the
HI AL
button (28) to switch between the following alarm
SET
functions:
• Alarm (hour/minute) (24)
• High room humidity alarm (14)
• High room temperature alarm (12)
• High outside humidity alarm (20)
• High outdoor temperature alarm (18)
• High absolute atmospheric pressure alarm (5)
The applicable display begins to flash.
• In alarm mode (4/11/16/21), repeatedly press the
LO AL
button (28) to switch between the following alarm
SET
functions:
• Alarm (hour/minute) (24)
• Low room humidity alarm (14)
• Low room temperature alarm (12)
• Low outside humidity alarm (20)
• Low outdoor temperature alarm (18)
• Low absolute atmospheric pressure alarm (5)
The applicable display begins to flash.
• In the corresponding display, press the
(30) or the button (31) to change the alarm value, and
+
confirm your selection by pressing the
• In the corresponding display, press the
activate/deactivate the corresponding alarm function.
• If the alarm is activated, the corresponding symbol
(6/10/15/26), (4/11/16) and/or
HI AL
displayed.
• If you do not make an entry for 20 seconds, you
automatically exit setup mode. Alternatively, press the
button (32) to exit setup mode before
SNOOZE / LIGHT
selecting all the values.
Note
• The set value is displayed for alarms that are already
set, deactivated alarms are indicated by --- or --.
button (29) to access
(4/11/16/21) alarm mode.
MIN/MAX
button (28).
SET
button (29) to
ALM
(4/11/16) is
LO AL
HI AL
button