EINHELL BG-SH 1 Bedienungsanleitung Seite 10

Anleitung_BG_SH_1_SPK1:_
GB
Assumed sound protection (APV) (dB)
Frequency (Hz)
Average sound insulation (dB)
Standard deviation (dB)
Assumed sound protection (APV) (dB)
Frequency (Hz)
Average sound insulation (dB)
Standard deviation (dB)
Assumed sound protection (APV) (dB)
Frequency (Hz)
Average sound insulation (dB)
Standard deviation (dB)
Assumed sound protection (APV) (dB)
Recommended level range:
High (H)
Medium (M)
Low (L)
Core sound insulation (SNR)
ID numbers, names and complete addresses of
the respective test organizations:
Helmet
N.B. 0197
Tüv Rheinland Product Safety Gmbh
Am Grauen Stein
D-51105 Cologne
Face protection and hearing protection
N.B. 0194
Select International UK Ltd
23-25 Friar Lane
Lelcester
LE 1 5QQ. England
5. Assembly
See Fig. 3a-3h
10
06.02.2009 7:00 Uhr Seite 10
27,0 6. Adjustments
2000
6.1 Neck strap
31,6
The safety helmet can be adjusted to the
3,3
circumference of your head by turning the neck strap
adjuster (Fig. 2 / Item 5). Turning it clockwise will
28,3
reduce the circumference, turning it anti-clockwise
4000
will increase the circumference. Only use the helmet
33,6
after it has been adjusted correctly.
To achieve the correct adjustment of the safety
3,4
helmet at maximum circumference, place it on your
30,2
head so that the 4-point strap (Fig. 2 / Item 6) is taut
8000
on your head. Turn the neck strap adjuster clockwise
to tension the neck strap until the helmet sits
31,3
securely on your head without causing pressure.
2,7
28,6 6.2 Ear protection
The height and position of the ear protectors can be
adjusted. The height can be adjusted by sliding the
= 29 dB
ear protection capsules (Fig. 4a). Their position can
be changed by turning them (Fig. 4b). To make it
= 22 dB
easier to put the helmet on and take it off, the ear
= 14 dB
protectors can be moved out of the way. If the
= 25 dB
tension weakens, it can be adjusted by sliding the
ear protector adjuster (Fig. 4c/Item 4) towards the "+"
sign. The tension will be reduced if it is moved
towards the "-" sign.
6.3 Visor
The distance between your face and the visor can be
adjusted by moving the visor in the visor mounting as
shown in Fig. 5. If necessary the visor can be moved
out of the way by pulling it upwards.
6.4 Height adjustment
The height of the neck strap can be adjusted. To set
the required height, securely fit the retaining element
(Figure 6/Item A) to either the bottom position (Figure
6/Item B) or the top position (Figure 6/Item C).
Important: The retaining element must always be
set to the same height on both sides.