Siemens WFM501-E000H0 Bedienungs- Und Montageanleitungen Seite 76

Parameter setting
DE
Active parameter setting mode
• Keep pressing key < H > until level
• Keep pressing key < V > until the parameter to be set appears on the dis-
play.
• Press the key combination < H > + < V >.
The display shows the window for password entry.
• Keep pressing key < V > until the position currently flashing has reached the
desired value.
• Press key < H > to jump to the next position.
• Repeat steps 4 and 5 until the password has been entered completely.
• Confirm the password by the key combination < H > + < V >.
• The display switches back to the value for which the parameter is to be set.
Parameter setting
To set parameters proceed as follows:
• Keep pressing key < V > until the position currently flashing has reached the
desired value.
• Press key < H > to jump to the next position.
• Repeat steps 3 and 4 for all parameter positions.
• Confirm the parameter setting by pressing keys < H > and < V >.
Commissioning
• Open the ball valves, switch the heating on and open the radiator valve.
• Check the installation for airtightness and direction of flow.
• Seal the temperature sensor and flow sensor to protect it from manipulation.
• Remove the installation cover from the meter housing.
• Note the installation date, the meter numbers, any seal numbers, the old
and new meter statuses.
• Dispose of the used device in accordance with national regulations.
EN 74 CE2U5323xx
or is reached
Siemens Building Technologies