Installation Work; Dimensional Data; Fastening - Hitachi HARC I/O Installations- Und Betriebshandbuch

HARC I/O - Installation Manual
HARC I/O - xxxxxxxxxxxxxxxxxx
6 6

4. Installation work

When unpacking the HARC I/O, check that it has not suffered
damage during transport.

4.1 Dimensional data

4.2 Fastening

Perform the following procedure:
1 Remove the rubber supports
2 Unscrew the 4 screws from the top cover and remove it
3 Attach the box to the rear vertical board from the inside with M5 screws (not provided)
and place 3 mm washers on the outside to separate the box from the wall.
4 Reinstall the top cover. Be careful to position it correctly.
5 Keep free grated area for ventilation and cable connection.

Attention:
- Before applying power and turning
on HARC I/O you must ensure that:
1. All circuits to be connected are
correctly applied.
2. All H-Link connections have
been set up.
3. Follow the local regulations
for the electrical installation
of HARC I/O and associated
circuits.
Any unit that is not connected or is
not under power when turning on
HARC I/O, will not be recognised
and will have to be configured later.

Caution:
- The signals' cables should be as
short as possible. Keep a distance
of more than 150 mm from other
power cables. Don't wire them
together (although they may
intersect). If they must necessarily
be installed together, take the
following measures to avoid noise:
- Protect the signal cable with a
metal tube which is earthed at
one end.
- For communications, use
shielded wire which is earthed at
one end.

Danger:
- Always disconnect the power
supply for HARC I/O when handling
the machine, in order to avoid
eletrical discharges.
- Do not connect the interface to the
power supply until the installation
has been completed.
- Comply strictly with local security
codes and regulations when
connecting the machine to the
electric network.
- You will need a three-wire cable
(two cores and earth) with a
suitable plug at one end.
PMML0169A rev0 - 12/2007